MiCOM P632
Availability of the Bay Panel
graphics/symbols/xh_bw.gif graphics/symbols/xh_fw.gif

The Bay Panel is only available under these conditions:

1.

On the hardware side the protection unit must be fitted with the binary module X(6I 6O) to a slot supporting this module.

2.

By selecting and sending a bay type (with parameter MAIN: Type of bay) a bay type has been generated.

To access a selected event recording from either the panel level or from any other point in the menu tree, press the “READ” key graphics/xhelptemp/svg2png/svg_0254.png.

From the control and display panels (e.g. measured value panels or the bay panel) the user can access the menu tree level by pressing the “ENTER” key.

To return to the previously selected control and display panel from the menu tree level the user must simultaneously press the keys “Cursor up” and “RESET”. (If previously no panel was selected, i.e. after a system restart, then the bay panel, if available, is accessed.)

After the set LOC: Autom. return time has elapsed the protection unit will also return automatically from the menu tree level to the control and display panel last selected.

The user can move from a bay panel to a measured value panel by pressing the key “Cursor left” and back again by pressing the key “Cursor right”.